Hi, I need to replace all the knobs on my Hohner B2A bass as they’re slipping on the pots.
That’s 2 normal knurled knobs and 1 concentric/stacked knob. My preference is metal rather than the existing plastic ones, but anything that fits is better than what I have.
The lower outer part of the concentric knob is quite shallow and isn’t easy to find a replacement. I’m guessing that the other 2 normal knobs are standard 6mm?
Any help appreciated.
Thanks!
Marcus
Hi Marcus
Sorry, the Hohner Service Dept. says they no longer have these parts in stock as the instruments were discontinued a long time ago. You’re best off looking online or asking the staff at a decent guitar shop, should there be any left near where you live. I always found the staff at Thomann very helpful.
Cheers
Steve
1 Like
Thanks Steve
Yes I have checked around but will try them too.
The main issue is with the lower outer stacked knobs, as it’s very low profile. Most concentric lower knobs have a taller dial.
Cheers.
Marcus
Hi Marcus,
Have you tried to find knobs in non-music resources?
Electronic part suppliers: mouser, tme, digikey.
Mechanical part suppliers: bossard, elesa-ganter, essentra components, kipp
CAD catalogs: 3dfindit, traceparts
2 Likes
Thanks, I haven’t tried other manufacturers yet, but will do. But have now managed to source the 2 normal knobs and now just looking for the concentric stacked knob.
The difficulty here is the lower outer knob is much more shallow than most, only about 6mm high. Most seem to be around 10 or 12mm tall. I prefer metal to plastic or 3D printed.
There must be other guitar models with a similar concentric design. This can’t be the only one!
If You want to do that exceptionally perfect then good approach will be to made good workshop drawing of that knob and find some white-beard milling machine operator/turner and do that manually. Then find someone to make black surface. I propose to not paint that. I think that chemically treating will be the best. Maybe some phosphorus will be good. White-beard craftsmen likes such challenges If you will to meet them face to face. But I suspect they’ll charge a lot.
I think that 3D printing will not give You perfect quality. Even in metal.
1 Like